Inline Water Pressure Regulator User Manual
The inline pressure regulator is used for connecting the xBloom Studio coffee machine to a pressurized water supply. It can be used to reduce the incoming water pressure, ensuring the Studio operates within a stable and reasonable pressure range, providing you with delicious coffee. Please refer to the section below for more detailed information.
Please read this guide carefully before using this product and follow the instructions accordingly. If you have any questions or need assistance, please contact support@xbloom.com or an authorized seller.
Installation Steps
- Connect the pressurized water line: Attach the inline pressure regulator to a pressurized water source, such as a purified water supply line.
- Switch xBloom Studio water intake mode: Press and hold the right-side knob on the machine main panel for 3 seconds, then switch the intake mode to water inlet.
- Connect the pressure regulator: Connect the water inlet fittings to the water pipe according to the direction shown in the diagram.
⚠ Please note that the maximum water pressure for pressurized purified water should not exceed 170 PSI. - Activate the water flow by opening the valve on the pressure regulator.
- Please try to dispense water. If all functions normally, you can now start brewing!
- Close the valve when the device is not in use to stop the water flow.
Precautions
-
Water Pressure Limit: Ensure the water pressure for pressurized water does not exceed 170 PSI to protect the coffee machine and regulator from damage due to excessive pressure.
-
Valve Closure: It is recommended to close the valve of the pressure regulator when the coffee machine is not in use to conserve water and prevent accidental leaks.
-
Regular Inspection: Regularly check the pressure regulator and connecting pipes to ensure there are no leaks or damages, maintaining the equipment in good working condition.
-
Follow Guidelines: Adhere to all applicable safety procedures during installation or maintenance. Turn off all power sources and relieve system pressure before installing/removing equipment.
Maintenance and Care
-
Cleaning and Maintenance: Regularly clean the pressure regulator and connected tubes to prevent the accumulation of scale and impurities.
-
Seal Inspection: Check the seals at all connections to ensure there are no leaks.