This process will remove any mineral build up caused by your water source.
- Place a minimum 300mL container under the water outlet and make sure the machine is on. Consider protecting surfaces from potential spills caused by descaling solutions.
- Add 250mL of water to the reservoir and mix in the recommended amount of descaling solution (60-65mL of dilution). Reattach the reservoir to the machine.
- Press and hold the button on the back of the machine above the power cord for 10 seconds. When machine dispense approximately 200mL of liquid into the container, release the button.
- Wait for approximately 1 hour for the descaling solution to work.
- After the descale waiting period, press & hold the Button again for 10 seconds. Empty the container with the descaling solution.
- Rinse and refill the water reservoir to the MAX line with fresh water, then reattach to the machine. Press & hold the Button again until dispensing starts to dispense the entire tank of water. Release the button when the water reservoir is fully empty.
CAUTION:
Do not swallow or ingest the descaling solution.
Avoid using the machine while descaling.
Refrain from filling the water tank during the descaling process.